DX Cluster

Set DX Telnet Cluster parameters here. Currently only one set of access parameters is supported.

If you check Auto-connect to DX Telnet cluster, the program will do so when you start FT2000RC.

Three frequently used DX Cluster commands can be entered here. The buttons for the three commands are available at the bottom of the DX Cluster Tab left of the Connect button.

Setup Remote Server

Enter the parameters or select one out of the available list after clicking on the ... button:

Select DX Cluster

The list can be maintained in the file dxclusters.dat, see Data Files page.

Back to Documentation > Settings | Next: DX Cluster Options